unisonic technologies co., ltd UG5J npn silicon transistor www.unisonic.com.tw 1 of 3 copyright ? 2010 unisonic technologies co., ltd qw-r222-004,a npn digital transistor (built- in bias resistors) ? features * two dtc114y chips in a sot-353 package. * mounting cost and area can be reduced in half. ? structure * epitaxial planar type * npn silicon transistor (built-in resistor type) * halogen free ? ordering information pin assignment ordering number package 1 2 3 4 5 packing UG5Jg-al5-r sot-353 i1 g1,g2 i2 o2 o1 tape reel ? marking information UG5J 3 2 1 4 5
UG5J npn silicon transistor unisonic technologies co., ltd 2 of 3 www.unisonic.com.tw qw-r222-004,a ? absolute maximum rating (ta=25 ) parameter symbol ratings unit supply voltage v cc 50 v 40 input voltage v in -6 v i out 70 output current i c(max) 100 ma total power dissipation p d 150 (note 2) mw junction temperature t j +150 storage temperature t stg -50 ~ +150 notes : 1. absolute maximu m ratings are those values beyond which the device could be permanently damaged. absolute maximum ratings are stress ratings only and functional device oper ation is not implied. 2. 120mw per element must not be exceeded. ? electrical characteristics (ta=25 ) parameter symbol test conditions min typ max unit v i(off) v cc =5v, i o =100a 0.3 input voltage v i(on) v o =0.3v, i o =1ma 1.4 v output voltage v o(on) i o =5ma, i i =0.25ma 0.1 0.3 v input current i i v i =5v 0.88 ma output current i o(off) v cc =50v, v i =0v 0.5 a dc current gain g i v o =5v, i o =5ma 68 transition frequency f t v ce =10v, i e =-5ma, f=100mhz (note 1) 250 mhz input resistance r 1 7 10 13 k ? resistance ratio r 2 /r 1 3.7 4.7 5.7 note: 1.transition frequency of the device. ? equivalent circuit (the following characteristic apply to both dt r1 and dt r2 )
UG5J npn silicon transistor unisonic technologies co., ltd 3 of 3 www.unisonic.com.tw qw-r222-004,a ? typical characteristics collector current vs. collector- emitter voltage 0 collector current, i c (ma) collector-emitte r voltage, v ce (v) 1 0 1 3 4 5 6 2 2345 i b =19.6a i b =24.6a i b =29.6a i b =34.6a 6789 utc assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all utc products described or contained herein. utc products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. the information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice.
|
